MIL-DTL-25308C
3.18.1.4 Non-aluminum inserts. Castings containing non-aluminum integral inserts may be
treated with a chemical film in accordance with MIL-C-5541 may be used in lieu of anodizing.
3.18.1.5 Abrasion resistance. When abrasion resistance is a factor, parts shall be anodized.
3.18.2 Steel parts. Cadmium plating of steel parts, when used, shall be in accordance with
AMS-QQ-P-416, type II or III, as applicable, and of a class that is adequate to achieve the degree
of protection required.
3.19 Identification of product. Equipment, assemblies and parts shall be marked for
identification in accordance with MIL-STD-130.
3.20 Workmanship. The gage shall be constructed and finished in a thoroughly workmanlike
manner. Particular attention shall be given to neatness and thoroughness of soldering, wiring,
marking of parts and assemblies, and freedom of parts from burrs and sharp edges.
3.20.1 Dimensions. Dimensions and tolerances not specified shall be as close as is consistent
with best shop practices. Where dimensions and tolerances may affect the interchangeability,
operation or performance of the gage, they shall be held or limited accordingly.
3.20.2 Gears. Gear assemblies shall be properly aligned and meshed and shall be operable
without interference, tight spots, loose spots or other irregularities. Where required for accurate
adjustments, gear assemblies shall be free of backlash.
3.20.3 Screw assemblies. Assembly screws and bolts shall be tight. The word tight means that
the screw or bolt cannot be appreciably tightened further without damage or injury to the screw
or bolt or threads.
3.20.4 Cleaning. The gage shall be thoroughly cleaned of loose, spattered or excess solder,
metal chips and other foreign materials after final assembly. Burrs and sharp edges, as well as
resin flash that may crumble, shall also be removed.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as
follows:
a.
First article inspection (see 4.3)
b.
Conformance inspection (see 4.4)
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business