MIL-DTL-25308C
scale error test. The scale error shall not exceed twice the room temperature tolerance in table I.
No calibration shall be performed on the units during this test. The test may be interrupted for
weekend shutdown. The contractor shall prepare a report which shall contain test procedures,
details of any malfunctions and corrective actions taken. MIL-HDBK-781 may be used for
guidance in writing the report.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house
contractor personnel, these personnel need to contact the responsible packaging activity to
ascertain packaging requirements. Packaging requirements are maintained by the Inventory
Control Point's packaging activities within the Military Service or Defense Agency, or within the
military service's system commands. Packaging data retrieval is available from the managing
Military Department's or Defense Agency's automated packaging files, CD-ROM products, or
by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. The type ME-1 gage covered by this specification is intended for use in
indicating directly the pressure in hydraulic and pneumatic aircraft systems and for use in
locations other than the cabin or cockpit of aircraft where the temperature does not exceed 100°C
(212°F) when the gage is operating and 145°C (293°F) when the gage is not operating.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number and date of this specification.
b. When sampling plan B tests will not be conducted.
c. Special acceptance criteria if required.
d. Any special packaging or marking requirements.
6.3 Subject term (key word) listing.
Pneumatic
6.4 Changes from previous issue. Marginal notations are not used in this revision to identify
changes with respect to the previous issue due to the extent of the changes.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business