MIL-DTL-25308C
2.3 Non-Government publications. The following documents form a part of this document to the
extent specified herein. Unless otherwise specified, the issues of these documents are those cited
in the solicitation or contract.
SAE INTERNATIONAL AEROSPACE
SAE AMS-QQ-P-416 -
Plating, Cadmium (Electrodeposited)
SAE AS5202
-
Port or Fitting End, Internal Straight Thread, Design
Standard
(Copies of SAE documents are available from SAE International, 400 Commonwealth Drive,
Warrendale, PA 15096-0001 or on-line at www.sae.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a
conflict between the text of this document and the references cited herein (except for related
specification sheets), the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 Materials.
3.1.1 Nonmagnetic materials. Nonmagnetic materials shall be used for all parts of the gage
except where magnetic materials are essential.
3.1.2 Nonferrous materials. Nonferrous materials shall be used for all parts of the gage except
where ferrous materials are essential.
3.1.3 Metals. Metals shall be corrosion-resistant or suitably treated to resist corrosion due to
fuels, salt fog, or atmospheric conditions likely to be met in storage or normal service.
3.1.4 Dissimilar metals. Unless suitably protected against electrolytic corrosion, dissimilar
metals shall not be used in intimate contact with each other. Dissimilar metals are defined in
MIL-STD-889.
3.1.5 Toxic and corrosive fumes. The gage shall be of such material and construction that
fumes, when burned, or gases that combine with the atmosphere to form acid or corrosive alkali
will not be liberated.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business