MIL-PRF-62430B
3.6.11 Basic shock. The harness shall meet the specified performance requirements
without malfunction when subjected to half sine wave shock pulses of 30±3 g (294±29 m/s2) for
18 ms duration in any direction (see 4.5.6.11).
3.6.12 Submergence. The harness shall meet performance requirements after
submergence in water (see 4.5.6.12).
3.7 Identification marking. Identification marking shall be in accordance with
ANSI/SAE AS478 and as noted on the applicable drawing (see 4.5.2).
3.8 Workmanship. MIL-HDBK-454, Guideline 9 (Workmanship) shall be used as
guidance for workmanship for the harnesses (see 4.5.7).
3.9 Safety. MIL-STD-882 and MIL-HDBK-759 shall provide design guidance for
design safety review, safety hazard levels, safety precedence, analysis, action on identified
hazards, and safety testing (see 4.5.8).
4. VERIFICATION
4.1 Classification of inspections. Inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.3)
b. Conformance inspections (see 4.4)
1. Examination (4.4.2)
2. Acceptance tests (see 4.4.3)
4.2 Inspection conditions. Unless otherwise specified (see 6.2), all inspections shall be
performed under the following conditions:
a. Temperature
-
73±18 °F (23±10 °C)
b. Pressure
-
28.5 +2/-3 inches (in.) (725 +50/-75 millimeters (mm))
mercury (Hg)
c. Relative humidity
-
50±30%
4.2.1 Test tolerances. Unless otherwise specified (see 6.2), test conditions, as indicated
by instrumentation, shall not deviate from the conditions specified herein by more than the
following:
a. Temperature
Under 100 °F (38 °C)
-
±4 °F (±2 °C)
Over 100 °F (38 °C)
-
±4%
b. Pressure
-
±5%
c. Relative humidity
-
±5%
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business